Industrial Steel Door Assembly Video

1. Remove the steel door by lifting & put the steel door frame in place.

2. Adjust the steel door frame to suit the opening by tightening the 6 bolts with 12mm Allen key.
When adjusting the steel door frame to suit your opening do not over tighten the Allen keys.

3. Drill through the centre of the Allen key bolts into the blockwork with a 10mm drill.

4.When fitting the steel door frame make sure that it is fitted square & plum. (If the steel door frame is not square and plum the shot bolts in the steel door could jam in the frame.) Use 6 anchor bolts to fix the steel door frame into place.

5. Place the steel door back onto its hinges. Check the gap around the steel door and frame is equal.

6. Fix the 2 screw connectors to the outside handle. Insert the spring into the spindle drive followed by the large shaft.

7. Fit the other spring and the smaller shaft to the inside handle. When fitting the steel door furniture make sure the spindles are inserted correctly.

8. Secure the inside handle with the 2 screws. When fitting the steel door handles do not over tighten the screws (this could jam the lock).

Your steel door is now fully installed and ready to use.